5 things you never want to see in your clean room

The inside of your cleanroom is protected from dirt, like gloves and clothes. As with any constraint, the six components of your clean room don’t work well in certain situations. Anything that disturbs the smooth surface is a potential contamination risk. Here are 5 common mistakes people let into their cleanrooms.

There is a high quality. Any scrub, crack, dent, hole, sharp corner or raised area can be a nightmare. This applies not only to the surrounding building, but also to the frame and other elements in the building. Pay close attention to flat surface integrity and avoid work that requires drilling or adding weight to walls or ceilings.

They are the rivets. These are used to connect panels or to hold blinds or windows in place. Rivets are useful in some situations, but are never necessary. If they are after flashing or trimming, it’s fine as long as it doesn’t show inside the cleanroom. You can’t have someone drill a hole in an uncontrollable area of ​​your floor or remove a layer of silicone from your wall that can never be fully cured.

The bolts of the mushrooms. These support the sandwich panel roof, do not remove them if you have found them on your property. A concealed roof cannot be installed on it. However, if you are starting from scratch, make sure your contractor uses a concealed clean room seal that will not break.

There are electrical outlets on all sides. For example, if you’re building your own white house and you have a separate security contract, you can’t have security start scouring your walls for orange electrical appliances. Before you hire someone who is in a position to do so, talk about this.

Go through the boxes in the wrong order. If you use a through box, one wall will have to come out. When transferring material from a class C room to a class B room, the room in class C shall be free from vibration. The Grade B area should be treated equally: there should be no openings on either side of the building.

Your point of support should be as close to a smooth hexagonal box as possible. This can reduce dead space, improve airflow, and reduce small areas where dust, dirt and other contaminants can hide. The shoes are faster and easier to clean.